Loading
 
Quantity
 

P115W-A2W is a plug-in version with heavy duty circuitry, which can handle the newer Xenon type bulbs. This unit is externally mounted.

P115W-A2W is designed for Harley Sportster (earlier models), some Japanese sport bikes and other european scooters with a 2-pin connector that plugs into the 9000 series Hi-beam bulb. Typically these bulbs have an elbow connector.

Note! The pin spacing is wider than the H8/H9 series bulbs. Use P115W-A2 for that application.

Unit is 1.0'' (25.4mm) by 1.35'' (34.4mm), and externally mounted. The matching 2-pin connector makes this a plug-n-play operation.

pathBlazer circuit modulates the hi-beam current - from 100% ON to about 17% OFF. This is accomplished by using dual p-channel MOSFETs, which are inherently safe. The MOSFET is designed to fail in the ON state. For additional safety, the circuits do not utilize the lo-beam whatsoever!

MAX power rating is 115 watts. Do not exceed !

P115W-A2W comes with a detachable daylight sensor, which simply plugs into the pathBlazer. The daylight sensor functions as a switch; it stops modulation when it cannot see enough daylight. Since the internal circuitry is controlled by a microprocessor, it allows for customizable features.

Programmable Daylight Sensor

If you turn the high beam on and then turn the ignition on three times quickly, the sequence is interpreted as an active command to change the sensitivity.

Current software version v.823A allows 8 linear steps between the high and low end. Older models have two settings only.

The daylight sensor has a low frequency filter to avoid false triggering. Please note that florescent lamps may not trigger the sensor - it needs constant incandescent light.

pathBlazer uses a soft-switching technique. It throttles the current flow through the bulb filament, so that there's no ''thermal shock'' due to a sudden inrush of current, which can damage the bulb filament or shorten its life considerably. This is far superior than maintaining a small voltage!

Select hi-beam to modulate - as long as there's sufficient daylight. If you enter a tunnel or if it gets dark, it will stop the modulation of the hi-beam and stay ON steady. Select lo-beam to end modulation.

 Premier Cycle Accessories
9411 Mercantile Drive  |  Mentor  |  Ohio  |  44060  |  t. 866.841.9256  |  f. 440.352.3880  |   e.
Kisan Head Light Modulator pathBlazer - Part No. 3939